Welcome sheepdogs to another video brought to you by Tampa Carry. My name is Ryan and in this video, I’m going to show you how to properly clean a semi-automatic pistol. We’ll discuss frequency, supplies, and a detailed process to maintain your firearm, so stay tuned. Cleaning your firearm for the first time can be an intimidating process. But I promise, if you follow these steps, it’s gonna be a breeze. It’s important to clean your firearm after each trip to the gun range. This ensures your firearm is in good condition if an emergency arises. It’s also recommended to apply a light coat of oil on your firearms between trips to the range. This could mean applying oil every few weeks or it could be every six months. It really depends on how much moisture or humidity your firearm is exposed to on a daily basis. The majority of your firearm is made out of metal which will rust or corrode if free from oil. A light coat of oil is all you need to prevent long-term damage to your firearm. To properly clean your firearm, you’re gonna need a few supplies. You will need foaming bore cleaner, gun oil, a bore snake, gun cleaning brushes, q-tips, and an old rag. I’ll include links in the description below for some of these items. The most important part of cleaning your firearm is gun safety. Far too many people are killed while cleaning their firearms because they don’t follow the rules. Rule number one, always keep your finger off the trigger. Rule number two, always keep your firearm pointed in a safe direction. A safe direction should be an exterior wall in your home. Today, most homes are built with a concrete exterior wall. If your firearm goes off, the bullet is unlikely to pass through a concrete wall. However, interior walls are made of drywall and a bullet will pass through like a hot knife through butter. Potentially killing a loved one on the other side. Rule number three, always make sure your firearm is unloaded. This process is called safety checking your firearm. I’ll include a link, to another video to properly show you how to safety check your firearm. First, lay an old towel on your table so that you don’t damage it with any solvents. Next, you need to field-strip your firearm. This is the process of separating the slide from the frame and removing the barrel. Most firearms have a different process to field-strip the gun. If you’re unsure on how to do this, refer to the owners manual for detailed instructions. Now, that your firearm is disassembled, spray foaming bore cleaner into the barrel and Allow it to sit for two to three minutes. Next, we’ll begin to wipe away any carbon from the slide, the frame, and the outside of the barrel using our rag. For stubborn spots, apply a small amount of gun oil and scrub with a brass brush then wipe it clean. To clean the hard-to-reach spots, i like to use q-tips. Apply a small amount of oil and wipe clean. Now, we’re ready to clean the inside of the barrel. Drop the weighted end of the bore snake through the barrel and pull it out the other side. Then hold the barrel up to light and you should see a bright shiny barrel. Next, apply a small amount of oil to your fingers and rub the outside of the barrel, the guide rails, and the internal parts of the slide and frame. Don’t apply too much oil. A small amount goes a long way. Now, you can reassemble your firearm by simply reversing the process you used to field-strip your gun. Once the firearm is reassembled, apply a light coat of oil to the outside of the firearm and the magazine. That’s it! Your firearm is clean and it’s ready for anything. I hope you enjoyed this video. If you did, give it a big thumbs up and if you haven’t already, subscribe to the Tampa Carry youtube channel for more amazing videos like this. In the comments below, tell me what kind of gun you have and what you like about your gun. I’d love to hear from you and until next time. Stay safe.